pro mix potting soil

Particle weight, size, shape, surface configuration, and medium type are the main factors that determine which of these processes operate. * Raindrop impact: the force of a raindrop falling onto a soil or weathered rock surface is often sufficient to break weaker particle bonds. The amount of force exerted by a raindrop is a function of the terminal velocity and mass of the raindrop. Figure 1 is an image that was created from DEMs (Digital Elevation Model) for the following 1:24,000 scale topographic quadrangles: Telescope Peak, Hanaupah Canyon, and Badwater, California. To the left is the Panamint Mountain Range. To the right is Death Valley. Elevation spans from 3,368 to -83 meters and generally decreases from left to right. The blue line represents an elevation of 0 meters. Large alluvial fans extending from a number of mountain valleys to the floor of Death Valley can be seen in the right side of the image. The sediments that make up these depositional features came from the weathering and erosion of bedrock in the mountains located on the left side of the image. (This image was created with MacDEM software). Erosion is defined as the removal of soil, sediment, regolith, and rock fragments from the landscape. Most landscapes show obvious evidence of erosion. Erosion is responsible for the creation of hills and valleys. It removes sediments from areas that were once glaciated, shapes the shorelines of lakes and coastlines, and transports material downslope from elevated sites. In order for erosion to occur, three processes must take place: detachment, entrainment and transport. Erosion also requires a medium to move material. Wind, water, and ice are the environmental media primarily responsible for erosion. Finally, the process of erosion stops when the transported particles fall out of the transporting medium and settle on a surface. This process is called deposition. Figure 1 illustrates an area of Death Valley, California where the effects of erosion and deposition can be easily seen. * Saltation is where the particle moves from the surface to the medium in quick continuous repeated cycles. The action of returning to the surface usually has enough force to cause the entrainment of new particles. This process is only active in air and water. Entrainment Forces * Cavitation: intense erosion due to the surface collapse of air bubbles found in rapid flows of water. In the implosion of the bubble, a micro-jet of water is created that travels with high speeds and great pressure producing extreme stress on a very small area of a surface. Cavitation only occurs when water has a very high velocity, and therefore its effects in nature are limited to phenomenon like high waterfalls. The main force reponsible for entrainment is fluid drag. The strength of fluid drag varies with the mass of the eroding medium (water is 9,000 times more dense than air) and its velocity. Fluid drag causes the particle to move because of horizontal force and vertical lift. Within a medium of erosion, both of these forces are controlled by velocity. Horizontal force occurs from the push of the agent against the particle. If this push is sufficient to overcome friction and the resistance of cohesive bonds, the particle moves horizontally. The vertical lift is produced by turbulence or eddies within the flow that push the particle upward. Once the particle is lifted the only force resisting its transport is gravity as the forces of friction, slope angle, and cohesion are now non-existent. The particle can also be transported at velocities lower than the entrainment velocities because of the reduction in forces acting on it. Introduction